OpenGL Subsystem ?

[old.Fury161]

When I try to run quake3 I get a message in the quake3 console that says......GLW_Start OpenGL()-could not load OpenGL Subsystem.
Everything was working fine until today,I've reinstalled quake3 a couple of times but I still get the same results.

Anyone got any Ideas on what is happening and how I fix it?

 

[kryt]

WHat graphics card are you using? nVidia one? if so, grab a copy of the latest Detonator 3 drivers.. if its an other card (does anyone these days not use nvidia?) then get the latest drivers. This is of course, you have a 3d card.

 

[old.Fury161]

Originally posted by Kryten
WHat graphics card are you using? nVidia one? if so, grab a copy of the latest Detonator 3 drivers.. if its an other card (does anyone these days not use nvidia?) then get the latest drivers. This is of course, you have a 3d card.

Riva TNT2 Vanta.......
System is ....Dell Dimension L500CX
Celeron
Riva TNT2 Vanta
192ram

 

[TarX]

errrm i got that error
it was caused by i installed the Quake3 patches wrong so i started themk again and it worked so try that

ps im tired so it porb wont make since